SHOP FLOOR TOOL
Tube Miter
Cut Assistant
Geometry
0 mm = full-through miter. A positive value leaves a straight end segment.
End A · left
End B · right
Live view
Verify end identity, top/bottom face, blunt-edge side, scrap side, kerf and one first-off part.
Stock Optimizer
Plan
Enter demand and tap Optimize.
Compound Cuts
Tapered box or pyramid
SAW SETTINGS—Miter angle (saw scale)
—Bevel / blade tilt (° from vertical)
SLANT HEIGHT—
EDGE OFFSET—
Set blade tilt first, then miter. Verify the setup on scrap.
Board Feet
Lumber volume
—
VOLUME m³—
TOTAL COST—
WITH WASTE—
Calculator
Trigonometric keys use degrees.
Help & Safety
Angle definition
Angles are measured from a square cut. A square cut is 0°.
Miter direction
Parallel miters have parallel end cut lines. Opposed miters face toward or away from each other.
Blunt edge
0 mm means a full-through miter. A positive blunt edge leaves a straight segment at that end.
Pointed and V-notch
Each shaped end uses two independent cuts. Enter both angles, or enter Cut 1 plus the junction position and let the app calculate Cut 2.
Compound cuts
Compound cuts combine a miter setting and a blade tilt. Confirm the work face, scrap side and setup on a test piece.
Board feet
Board feet are calculated from the entered metric dimensions. Cost is calculated from cubic metres, with the optional waste factor applied to purchasing cost.
Workflow
- Select the geometry.
- Enter dimensions and angles.
- Check Live View and driven dimensions.
- Confirm hand, top/bottom face and scrap side.
- Inspect one first-off part before batch cutting.